Microwave Medium Severity
SE Appliance Error Code

Jenn-Air Microwave SE Error: Sensor Error

What Does Jenn-Air Microwave Error Code SE Mean? Error code SE on a Jenn-Air microwave is a general sensor error indicating one or more internal sensors are returning abnormal data. This code covers the temperature sensor, humidity sensor, and meat probe input. Common Causes Sensor degradation from age and use is the primary cause. The […]

By Sarah Mitchell Appliance Safety Researcher & Technical Editor

Quick Assessment

Answer to continue safely

Is it safe to keep using?

Maybe. Manual microwave heating should work. Sensor and combination modes will be unreliable until repaired.

Can I reset the code?

Yes. A power cycle may clear a temporary glitch. Hardware sensor failures will recur.

When to stop immediately?

Stop if you notice: Manual heating also fails, Any sparking or arcing.

Symptoms You May Notice

All sensor programs unavailable

None of the auto-sensor cooking programs can be selected or used.

Temperature display reads incorrectly

The probe or cavity temperature shows unrealistic values during cooking.

Combination modes fail to start

Microwave-convection combination cooking will not initiate.

Possible Causes

1

Multiple sensor degradation

Several sensors (temperature, humidity, or probe) have drifted out of range simultaneously.

Requires Professional
2

Control board sensor input failure

The input circuit on the control board that reads sensor data has a fault.

Requires Professional

Safe Checks You Can Do

These checks are safe for homeowners. No disassembly required. Do not remove panels or access internal components.
  1. 1

    Power cycle the microwave

    Turn off the breaker for 5 minutes and try again.

    SE can sometimes be triggered by a temporary glitch in the sensor processing circuit.

  2. 2

    Test manual cooking

    Use manual time and power settings to verify basic microwave heating works.

    If manual mode works, the magnetron is fine — only the sensor system is affected.

When to Call a Professional

Contact a qualified technician if:

  • Multiple sensor readings out of range
  • Board sensor inputs show incorrect voltage
  • Diagnostic mode shows sensor faults

Need Professional Help?

Find qualified technicians in your area for proper diagnostics and repair.

Microwave Repair Service Schedule Appointment

More Microwave Error Codes

View all codes →
F9 F6 F4 PF F8 F7 F3 F5 F2 F1