Dishwasher Low Severity
FAE5 Appliance Error Code

Jenn-Air Dishwasher FAE5 Error: Cycle Completion Error

What Does Jenn-Air Dishwasher Error Code FAE5 Mean? The FAE5 (also shown as F10-E5) error code on Jenn-Air dishwashers appears when a cycle ends abnormally. The dishwasher drains automatically when this error occurs but cannot start a new cycle until the error is acknowledged. Common Causes Temporary control glitch: A momentary communication error between the […]

Quick Assessment

Answer to continue safely

Is it safe to keep using?

Yes. This is a communication error — no safety hazard. The dishwasher is safe to use after clearing the code.

Can I reset the code?

Yes. Press Cancel twice to clear. If recurring, a power cycle usually resolves it.

When to stop immediately?

Stop if you notice: Error occurs on every cycle attempt, Other error codes appear alongside FAE5.

Symptoms You May Notice

Dishwasher stops before cycle finishes

The cycle ends prematurely — dishes may still be wet or have soap residue.

Cannot start a new cycle

Pressing Start has no effect until the error code is cleared by pressing Cancel twice.

Possible Causes

1

Temporary control glitch

A momentary communication error between the user interface and main control board caused the cycle to abort.

DIY Possible
2

Loose ribbon cable connection

The ribbon cable connecting the door interface to the main board may be loose due to vibration.

Requires Professional

Safe Checks You Can Do

These checks are safe for homeowners. No disassembly required. Do not remove panels or access internal components.
  1. 1

    Clear the error and restart

    Press Cancel twice, wait 30 seconds, then select a cycle and press Start.

    If the cycle completes normally after clearing, the error was likely a one-time glitch.

  2. 2

    Power cycle if Cancel does not respond

    Turn off the circuit breaker for 2 minutes, restore power, and start a new cycle.

    If this error appears repeatedly, the user interface board or ribbon cable may need attention.

When to Call a Professional

Contact a qualified technician if:

  • User interface board shows intermittent display issues
  • Ribbon cable connector is loose or corroded
  • Main board cannot communicate with door controls in diagnostic mode

Need Professional Help?

Find qualified technicians in your area for proper diagnostics and repair.

Dishwasher Repair Service Schedule Appointment