Jenn-Air Refrigerator IC Error: Ice Maker Module Error
What Does Jenn-Air Refrigerator Error Code IC Mean? Error code IC on a Jenn-Air refrigerator indicates a problem with the built-in ice maker module. The ice maker has either stopped producing ice entirely or is not completing its harvest cycle correctly. Common Causes The most common cause is a frozen water fill tube — the […]
Quick Assessment
Answer to continue safely
Is it safe to keep using?
Yes. An ice maker fault does not affect refrigerator or freezer cooling. The rest of the appliance operates normally.
Can I reset the code?
Yes. Toggling the ice maker off and on or pressing the reset button can restart the harvest cycle. If the module is mechanically failed, it will stop again.
When to stop immediately?
Stop if you notice: Water leaking from ice maker area, Ice maker makes grinding or knocking sounds.
Symptoms You May Notice
Ice production has stopped completely
The ice bin is empty and no new ice is being produced even though the freezer is at the correct temperature.
Ice maker arm or sensor stuck
The ice maker wire arm is in the up (off) position or the optical sensor light is not illuminated.
Partial ice cubes or hollow ice
The ice maker produces undersized or hollow ice cubes before stopping.
Possible Causes
Failed ice maker module
The motor and cam assembly inside the ice maker has worn out and cannot complete the harvest cycle.
Requires ProfessionalWater inlet valve failure
The valve that fills the ice maker tray is not opening, so no water reaches the mold.
Requires ProfessionalFrozen water fill tube
The small tube that delivers water to the ice mold has frozen shut.
DIY PossibleSafe Checks You Can Do
-
1
Check the ice maker switch
Verify the ice maker is turned on — the wire arm should be in the down position, or the switch set to ON.
On some Jenn-Air models, the ice maker has a small on/off toggle rather than a wire arm.
-
2
Inspect the water fill tube
Look at the small tube entering the ice maker tray. If frozen, use a hair dryer on low to thaw it.
A frozen fill tube is common when the freezer temperature is set below 0°F.
When to Call a Professional
Contact a qualified technician if:
- Ice maker motor does not cycle when tested
- Water inlet valve has no continuity on solenoid
- Fill tube freezes repeatedly after thawing
Need Professional Help?
Find qualified technicians in your area for proper diagnostics and repair.
Refrigerator Repair Service Schedule Appointment