Dishwasher High Severity
F1-E2 Appliance Error Code

Jenn-Air Dishwasher F1-E2 Error: Motor Board Error

What Does Jenn-Air Dishwasher Error Code F1-E2 Mean? Error code F1-E2 on a Jenn-Air dishwasher indicates the motor control board has failed. This secondary board controls the power delivery to the wash motor and drain pump — the two components that move water during the wash and drain cycles. Common Causes The motor board can […]

Quick Assessment

Answer to continue safely

Is it safe to keep using?

No. Without a working motor board, dishes will not be washed and water may not drain. Do not add detergent or start cycles.

Can I reset the code?

Yes. A reset may allow one cycle to complete, but the board fault will likely recur.

When to stop immediately?

Stop if you notice: Motor does not start at all, Water remains standing in the tub.

Symptoms You May Notice

Wash motor does not run

The dishwasher fills with water but the spray arms do not spin because the motor is not powered.

Drain pump not activating

Water remains in the tub after a cycle because the drain pump is not receiving power.

Humming noise without wash action

A buzzing or humming from beneath the tub without any water movement.

Possible Causes

1

Failed motor control board

The secondary board that controls the wash motor power delivery has a component failure.

Requires Professional
2

Motor winding failure

The wash motor itself has a shorted or open winding, causing the board to fault.

Requires Professional

Safe Checks You Can Do

These checks are safe for homeowners. No disassembly required. Do not remove panels or access internal components.
  1. 1

    Power cycle the dishwasher

    Turn off the breaker for 5 minutes and restore power. Start a new cycle.

    If the motor runs briefly then stops, the motor board is likely failing under load.

  2. 2

    Listen for motor sounds

    After starting a cycle, listen under the dishwasher for the motor. A hum without water movement suggests the motor is jammed or the board is faulty.

    Check for debris in the sump area that might be jamming the motor impeller.

When to Call a Professional

Contact a qualified technician if:

  • Motor board shows heat damage
  • Motor draws excessive amps
  • Board output voltage is absent or incorrect

Need Professional Help?

Find qualified technicians in your area for proper diagnostics and repair.

Dishwasher Repair Service Schedule Appointment